Cable Pull Distributor Slider Hub 45 mm

Cable pull distributor with screw cap

Stroke 45 mm

1 input with M 6 adjusting screw

3 outlets with 6.5 mm hole

Holder for solder nipple in slider D = 3.2 mm L = 5.0 mm

Suitable attachments :

Cable 1.5 mm ( 100174 or 100175 )

Bowden cable sleeve ( 100190 )

End sleeves ( 100120 )

Solder nipple ( 100073 )

Cable distributor for 3 mm cable, stable design
Material Niro (1.4301)

Technical information on the item and accessories:

Item number for Set with screws and threads : Art : (101772)
Recommended rope : 3 mm rope 1×19 galvanized ( Art. No. : 100203 )
Recommended sheath : Flat wire spiral with inner tube ( Art. No. 100202)< br />
Reference dimensions :

Carrier :
Total length : 190 mm
Front width : 45 mm
Back width : 65 mm
Component height: 35 mm
Material thickness: 3 mm
Hole diameter on the holder: 14 mm
Hole spacing at the back: 40 mm
Distance of screwing holes at the back: 40 mm for M 6
Distance between screwing holes at front: 30 mm for M 6
Distance between screwing holes at rear in front: 153 mm 

Sliding carriage:

Bore diameter  6.5 mm 2x for rope attachment
Hole diameter 9 mm 1x for rope attachment
Hole spacing: 40 mm
Material thickness 3 mm

Other information:

Stroke: approx. 60 mm
Caution: assembly of the sliding carriage as shown in the picture.
The long flange of the sliding carriage must point with the large holes to the underside of the carrier and the long tab must point to the side with the 2 mounting holes.