HHM – 70 Hydraulic press tool without tool inserts l
Pressing pressure 35 tonnes
Weight : 37,5 KG
Dimensions : 330x220x390 mm

We would be happy to press the nipple on one side of your rope.
Please book this service as well if you want us to press the nipple onto your wire or rope.

The price refers to 1 rope
When ordering, enter the amount of ropes you want the nipples to be crimped on.

When squeezing, the shapes of the nipples change as follows :

Longitudinal nipples / trumpet nipples are pressed as a hexagon.

Cross nipples are pressed on the front side via point pressure, the diameter increases slightly as a result of the pressing.

Manual crimping tool for rope ends

For use in a vice

With this pressing tool, threaded rods and eyelets can be pressed quickly and easily.

Application :

– Insert the tool in the vice

– Push the part to be pressed onto the rope

– Press on 2 notches at the beginning and end of the rope and then press on again in the center of the notches, rotated by 180 °

The depth of the notches and thus the strength of the pressing depends on the type of rope and the part to be pressed. We point out that it is a tool for non-safety-relevant parts.

Threaded Rod: M4 x 34 mm

Material: steel galvanized

Dimensions:

Thread: M 4

Thread length in mm: 23

Total length in mm: 34

Drilling diameter in mm: 1.2

Drilling depth in mm: 10

Shaft diameter in mm: 4

Threaded Rod: M4 x 22 mm

Material: steel galvanized

Dimensions:

Thread: M 4

Thread length in mm: 11

Total length in mm: 22

Drilling diameter in mm: 1.7

Drilling depth in mm: 10

Shaft diameter in mm: 4