HHM – 70 Hydraulic press tool without pressing tools

Manual crimping tool for rope ends

For use in a vice

With this pressing tool, threaded rods and eyelets can be pressed quickly and easily.

Application :

– Insert the tool in the vice

– Push the part to be pressed onto the rope

– Press on 2 notches at the beginning and end of the rope and then press on again in the center of the notches, rotated by 180 °

The depth of the notches and thus the strength of the pressing depends on the type of rope and the part to be pressed. We point out that it is a tool for non-safety-relevant parts.